![]() ![]() An example is when trying to open the Option Parameters in a 50 controller. You will see the prompt "Open the menu setup parameters?"Ī key point to know about an M50 controller as well as, in some cases, the M500 series controller is that you may be required to press the INPUT/CALC button more than once. In order to access the Machine Parameters in an M50 control you cannot use 1001 M. ![]() If the 50 controller displays NO MODE check the NC-SPEC page, if no data is displayed beside PLC the PLC is gone. On a Mitsubishi 50 controller the PLC is stored in non-volatile ROM. On an M50 controller, if you want to view the macro programs change Parameter 1121 to 0. Mitsubishi M50 controllers look very much like the M500 series but differ in many ways. To access the communication parameters on a Meldas 64 controller: To get into the "machine parameters" you have to select yes when prompted to "OPEN THEMENU SETUP PARAMETER". The parameters are numbered the same way. The Mitsubishi 64 controller is much like the 50 series.
0 Comments
Leave a Reply. |